[PEDA] Mouse Scroll Wheel in Protel 99SE/Dual Screens

[Dennis Saputelli]

this sounds about consistent with what brad & i have said

brad, i didn't notice it (sch issue) as closely as you did but putting 
the sch on one monitor solved the issue, too bad

AD6 doesn't do this and am also playing with manual routing, it seems 
pretty good and smart at that but i am nowhere up to speed on the program

ds


_______________________________________________________________________
Integrated Controls, Inc.           Tel: 415-647-0480  EXT 107
2851 21st Street                    Fax: 415-647-3003
San Francisco, CA 94110             www.integratedcontrolsinc.com


Robert Mitchell wrote:
> Brad Velander wrote:
> I also use 2 screens but do not attempt to have 99SE fill the whole space.
> I place the working area, eg, the schematic on one screen and the other 
> panel on the second screen so that the split lies along the join between 
> the two sections of the work area. I have moved the tool bars into that 
> area as well so that the schematic, itself is as big as possible within 
> the confines of a 20" monitor. This leaves an amount of working area on 
> the other screen which I use for pdf datasheets, email and anything else 
> I might want to use while working on a Protel projec.
> I find that this works well for me.
> 
> Bob Mitchell
> 
> 
> 
> ---
> avast! Antivirus: Outbound message clean.
> Virus Database (VPS): 0625-5, 21/06/2006
> Tested on: 22/06/2006 11:44:14 AM
> avast! - copyright (c) 1988-2006 ALWIL Software.
> http://www.avast.com
> 
>