[PEDA] Mouse Scroll Wheel in Protel 99SE/Dual Screens

[Brad Velander]

Morning Dennis,
	Gee, great minds think alike.

	I guess the schematic problem you mention is the same one that I mentioned, where the split jumps to 1/2 way across the right monitor when you just click along a vertical axis 3/4 across the right monitor?

Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
#14 - 1925 Kirschner Road,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2232 ext. 225
fax (250) 762-3374


-----Original Message-----
From: Dennis Saputelli [mailto:dsicon at integratedcontrolsinc.com]
Sent: Wednesday, June 21, 2006 9:01 AM
To: Protel EDA Discussion List
Subject: Re: [PEDA] Mouse Scroll Wheel in Protel 99SE/Dual Screens


ooooh ...

major potential issues with that
esp re loaded libraries

i have had so much trouble with that (running 2 instances of P99SE) that
whenever it happens by mistake i shut down BOTH and then start up 1 again
i have absolutely found this required, but i can't remember all the 
details of why

i use dual monitors w/ 99SE
i have a lot of trouble when the schematic is spread across 2 screens
when i click on the right screen it gets confused
PCB seems ok
sch on one screen, pcb on the other seem ok

ds