[PEDA] Mouse Scroll Wheel in Protel 99SE/Dual Screens

[Dennis Saputelli]

ooooh ...

major potential issues with that
esp re loaded libraries

i have had so much trouble with that (running 2 instances of P99SE) that
whenever it happens by mistake i shut down BOTH and then start up 1 again
i have absolutely found this required, but i can't remember all the 
details of why

i use dual monitors w/ 99SE
i have a lot of trouble when the schematic is spread across 2 screens
when i click on the right screen it gets confused
PCB seems ok
sch on one screen, pcb on the other seem ok

ds

_______________________________________________________________________
Integrated Controls, Inc.           Tel: 415-647-0480  EXT 107
2851 21st Street                    Fax: 415-647-3003
San Francisco, CA 94110             www.integratedcontrolsinc.com


ajenkins at avtron.com wrote:
> One might also consider that dual screens can in some circumstances be
> productively employed by calling two instances of P99SE, one for each
> screen... 
> 
> aj
> 
> 
> 
> This e-mail transmission and its attachments may contain information from Avtron Manufacturing, Inc. that is proprietary, privileged and/or confidential and is intended exclusively for the person(s) to whom it is addressed. Any use, copying, retention or disclosure by any person other than the intended recipient or the intended recipient's designees is strictly prohibited. If you have received this message in error, please notify the sender immediately by return e-mail and delete all copies.
> 
>  
> ____________________________________________________________
> You are subscribed to the PEDA discussion forum
> 
> To Post messages:
> mailto:PEDA at techservinc.com
> 
> Unsubscribe and Other Options:
> http://techservinc.com/mailman/listinfo/peda_techservinc.com
> 
> Browse or Search Old Archives (2001-2004):
> http://www.mail-archive.com/proteledaforum@techservinc.com
>  
> Browse or Search Current Archives (2004-Current):
> http://www.mail-archive.com/peda@techservinc.com
> 
>