[PEDA] Floating, going to nowhere, Ratsnest line

[Steve Hendrix]

At 2006-06-28 00:38, you wrote:
>Protel 99 SE
>
>
>
>I move a pcb with components on it and low and behold, a ratsnest line
>remained !
>
>
>
>It appears to be going to nowhere, but I cannot delete it !!??
If you reload the netlist, the ratsnest should be updated. Sometimes 
this is the only way I've found to do it. If there are still ratsnest 
lines going off to nowhere afterwards, then zoom in very closely on 
the endpoint of the ratsnest line and there should be a primitive 
there for it to attach to. It's possible under some circumstances to 
have a zero length trace etc. that isn't visible at any zoom; then 
you may have to select an area around it and cut that selection.

Steve Hendrix